Brother HL-6182DW Driver Download

Brother HL-6182DW Driver lets the computer recognize this print-only laser printer and send jobs to it correctly. After installation, print commands can travel through the selected USB, wired network, or wireless setup. The software manages printing only, because the hardware has no scanner, copier, or fax section. Device recognition and output handling stay tied to the active connection.

Brother HL-6182DW Specifications

Brother HL-6182DW is a monochrome laser printer built only for printing. The chassis carries no scanner, copier, automatic document feeder, or fax hardware. Printing relies on an electrophotographic laser engine, with toner and drum supplies kept separate. Standard memory starts at 128 MB. One 144-pin DDR2 SO-DIMM slot can raise memory to 256 MB. A 16-character, single-line LCD shows menu and status messages on the control panel.

Print resolution reaches 1200 × 1200 dpi. HQ1200 quality produces 2400 × 600 dpi output, and standard jobs can use 600 × 600 dpi mode. Single-sided printing runs up to 42 ppm on Letter paper and 40 ppm on A4. Automatic duplex printing reaches 18 sides per minute on Letter or A4. First print time is listed at under 8.5 seconds under the stated test conditions.

Paper input comes through a 500-sheet standard tray for plain, thin, or recycled stock. Supported sizes include Letter, A4, Legal, Folio, Executive, A5, A6, B5, and B6. A 50-sheet multipurpose tray takes thicker paper, bond paper, labels, and envelopes. Custom sheets in that feed path may measure from 3 to 8.5 inches wide. Printed pages collect in a 150-sheet face-down tray, and the rear face-up path exits one sheet at a time.

Automatic two-sided printing accepts Letter, Legal, and Folio sheets. Duplex media must be plain, thin, or recycled stock from 16 to 28 lb. A nearby computer can connect through Hi-Speed USB 2.0. Network printing can use Gigabit Ethernet through 10BASE-T, 100BASE-TX, or 1000BASE-T. Wireless printing runs through IEEE 802.11 b/g/n in infrastructure mode. With consumables installed, the body measures 14.6 × 15.1 × 11.3 inches, weighs 25.4 lb, and draws about 727 W while printing.