Brother MFC-L2960DW Driver Download

Brother MFC-L2960DW Driver helps the computer communicate correctly with this multifunction printer during everyday operation. After the computer recognizes the hardware, print, scan, copy, and fax commands can reach the machine with the selected settings. Wired and wireless connections carry these jobs while reducing repeated device-recognition problems. Documents and scanned files can then move between the computer and printer while retaining the intended settings and output.

Brother MFC-L2960DW Specifications

Brother MFC-L2960DW is a monochrome laser multifunction machine for printing, scanning, copying, and faxing. Printing comes from an electrophotographic laser engine backed by 256 MB of memory. The control panel carries a 3.5-inch colour TFT touchscreen. For longer originals, a 50-sheet automatic document feeder sits above the flatbed and can read both sides automatically. That duplex document path also applies to copying and fax transmission, so two-sided originals do not need to be turned over by hand.

Print resolution reaches 1200 x 1200 dpi. On one-sided jobs, speed rises to 34 ppm with A4 paper and 36 ppm with Letter. Automatic duplex printing is limited to supported sizes such as A4, where the rated rate is 16 pages per minute; Letter reaches 17. From Ready mode, a page sent from the standard tray can appear in less than 6.9 seconds.

The flatbed scans at up to 1200 x 1200 dpi, whereas originals fed through the ADF use up to 600 x 600 dpi. Software interpolation can raise scan output to 19200 x 19200 dpi, and copy resolution tops out at 600 x 600 dpi. Most paper goes into the 250-sheet standard tray. A separate manual slot accepts one sheet at a time, which is useful for envelopes or heavier stock that should not remain in the main tray. Printed sheets leave the machine face down, and the output area holds up to 120 sheets.

A nearby computer can connect over Hi-Speed USB 2.0, and wired networks use 10Base-T or 100Base-TX Ethernet. Wireless jobs can travel over 2.4 GHz or 5 GHz Wi-Fi, with IEEE 802.11a/b/g/n used in infrastructure mode. Wi-Fi Direct creates a direct wireless link without relying on the normal network router. With supplies installed, the body is about 410 x 421 x 319 mm and weighs 12.4 kg. Power draw is about 485 W during printing, falling to roughly 3.3 W in Sleep mode.